A SIMPLE METHOD OF FIXING YOUR REFLECTIVE FOIL INSULATION INTO THE LOFT OF YOUR HOME.

 Tools Needed

• scissors
• upholsterers staple gun/ small hammer and wide head tacks.
• tape measure

 Preperation and insulation.

• measure the loft area, and work out the lengths required to complete the job ie. 5 metres x 3 metres.
• unroll your material on a driveway, garden lawn or living room floor, cut two lengths of 5 metres , roll these up into rolls .
• Take your two rolls up to the loft with the staplegun.
• Start at the top "highest point" and work across, staple the material to the rafters.
• Once the first roll is completed, start the second roll and overlap by 20mm, the first section of material, staple to rafters, as you did with the first section of insulation.
• To finish off seal all joints with Foil Tape.
• You have now completed the first section of your loft,  Rest if required before you repeat the same steps on the next section of your loft.

Please call us on 01795 597912 or  597998  if you need any advice or help regarding insulation.

WITHOUT ISOL-ACTIF® M1	WITH ISOL-ACTIF® M1	WITHOUT ISOL-ACTIF® M1	WITH ISOL-ACTIF® M1
Incoming heat is reflected inside the building, instead of being absorbed by the walls. Due to the composition of ISOL-ACTIF® M1 reflecting films, over 90% of the warming rays are released inside your home.		ISOL-ACTIF® M1offers a double effect as it reflects the heat that builds up under the tiles back outside, thus substantially cooling the house.